![]() Pushing the button toward the machine turns it off. Pulling out on the bottom turns the machine on. Power Button – This is a hinged push pull button. The angle indicator is on the front of the table saw behind the height adjustment wheel. Blade Angle Adjustment Lever – This wheel changes the angle of the blade relative to the table. Blade Height Adjustment Wheel – This wheel adjusts the height of the blade Finally we have a extra wide gapped insert designed to be used with the Dado bladesį. We also have a zero clearance insert that is used when cutting thin strips that might fall into the gap of a standard insert. The one that is shown is the standard design with about an 1/8th inch gap on either side of the blade. Blade Insert – Simply an insert that fills the hole that is used to swap blades. Shown here is a pretty standard table saw blade.Į. There are a couple different types of blades that we will cover later. To lock it in place firmly press it down.ĭ. Fence Dog – This is the level locks the fence in place. Fence – This is a long guide parallel to the blade that is used to keep the work a constant distance from the blade during a ripping cut.Ĭ. Should any question arise that you cannot answer, don’t hesitate to contact your Employer.B. NOTE: Always promote a discussion on any of the topics covered in the Tool Box Talks. Keep your hand positioned on the fence as you are feeding stock.Īlways read and follow the owner’s manual carefully.Use a push stick for small pieces of wood and for pushing stock past the blade.Wear the appropriate personal protective equipment (PPE).Establish and follow lockout requirements for service or maintenance of the table saw.Ensure that anti-kickback and spreader devices are in place and adjusted correctly.Enclose the portion of the saw above the table with a self-adjusting guard that will adjust to the thickness of the material being cut and remain in contact with it.Ensure that the blade is designed for the type of cutting being done and fits the saw's arbor precisely.Ensure that the saw components (blade, guard, arbor, fence, etc.) are adjusted correctly and the blade is sharp.Maintain the blades and sharpen blade teeth on a regular basis.The blade needs to be as close to perfectly flat as possible and needs to stay that way during the cut. Maintain the blade so that the teeth are in line with one another.Use anti-kickback fingers to hold the stock down.When ripping stock, use a spreader to prevent material from squeezing the saw or kicking back during the process.Guards with anti-kickback devices or spreaders are not used or adjusted correctly, particularly when using wet or poor-quality lumber.They are more likely to occur when performing rip cuts, rather than crosscuts. Kickbacks occur when the blade catches the stock and throws it back toward the operator. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |